Classic Spider-Man Sitting Shelf Figure

Most shelf figures need a base. This one doesn't. The pose is built around an edge. He perches on a shelf lip, a monitor bezel, the top of a bookcase, the side of a desk, anywhere with about 4 cm of ledge under him. Legs hang over the front. There is no stand, no plinth, no acrylic rod holding him up at an angle. Four colors of PLA go in during the print. The red panels, the blue, the black webbing and the white eyes are separate filaments, loaded through the AMS and swapped layer by layer. That is the part worth paying for. A painted figure loses its face the first time it goes off a shelf onto a hard floor. This one is the same color the whole way through the wall. Layers are 0.16 mm. Close up you can find them if you go looking. At normal shelf distance, about an arm away, you don't. He is 10.5 cm tall measured head to toe, 4.7 cm across and 4.0 cm front to back. Roughly a coffee mug. Small enough that he doesn't take over a shelf, big enough that the spider on his chest reads from across the room. I print these one at a time and take the supports off by hand. Every figure gets looked at before it goes in the box. Spec block Height, head to toe: 10.5 cm / 4.1 in Width across: 4.7 cm / 1.9 in Depth: 4.0 cm / 1.6 in Material: PLA, four colors Layer height: 0.16 mm Finish: as printed, no paint or filler

Free shipping on orders over ₹599